Click and drag to rotate
HO NSWGR Signal Hut on Frame 3d printed

Not a Photo

Smooth Fine Detail Plastic
HO NSWGR Signal Hut on Frame 3d printed
HO NSWGR Signal Hut on Frame 3d printed

Not a Photo

HO NSWGR Signal Hut on Frame

Made by
3D printed in matte translucent plastic that showcases fine and intricate details.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
This is a NSWGR Signal Relay Hut used to house signalling relays and accompanying batteries.

This hut is built on a supporting frame presumably depending on the location.

A plan is available here which is a slight variation of this hut.

Note the point rod supports, holes have been printed in the legs for 0.015 inch wire.

There is a version of the hut that is placed directly on the ground that is available here.

While normally seen in automatic signalling areas they have been photographed beside lower quadrant signals where the signal lamp is electric, so the lamp is being powered by the batteries in the hut. It would seem that these lower quadrant signals with the huts could be well outside station limits, too far for the Station Assistant to carry the old style kerosene lamps to. This is just conjecture though.
What's in the box:
HO NSWGR Signal Hut with Supports - 2 Bay v10
3.94 x 1.93 x 3.72 cm
Switch to inches
1.55 x 0.76 x 1.47 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.