B2 M26M 6.7" (2003 to 2007) TD 18 to 20mm

The MacGregor sailboat (M26M) was produced with two different types of mast cross-section profiles.
See my web's chart to see cross-section Profiles: B2 & B3 & C3.   
The oldest boat masts used B3 (flat side cheeks) till 2003, then came B2 (curved sides), then in 2007 C3 with a round inside luff channel, which was also used on the Tatoo model sailboat.

This MastGate is for the B2 Profile mast  with a Track Depth between  19 to 20mm (measured from non-bent track area with a caliper). Also, the feed slot length should be  170mm  ( 6.7" ).

If your length or TD is different, contact TomLuQue@gmail.com to receive a worksheet of measurements.

2-year warranty/ for build version 5/31/19  v.100.5

Because spread-open slots are custom hand-made, your slot length may vary in length & width.  You may require a different MastGate to be built.

When you receive your MastGate insert, Do not trim the end tips of the insert for fitting.    Questions to Tom Luque  
Send an aft photo of the mast with a ruler taped next to the slot.  From a distance of 12".  to   info@MastGates.com

Not included: allen set-screw, 6-32 x 3/16" ; allen hex key.  drill & bit.
Do not drill hole in feed slot until after a successful fitting.