Black Natural Versatile Plastic
Watto's Junkyard Tusken Slayer Chassis (NPXL v3)
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$52.53
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This is the same product as our other Watto's Junkyard Tusken Slayer Chassis but the depth for the neopixel connector has been changed to support the new ShtokCustomWorx NPXL v3 Connectors with the new Long Pins.
This is a "Council" (no Masters here) chassis designed to fit the Watto's Junkyard Tusken Slayer (v1 or v2) hilt. This chassis is our highest tier design, the main body is printed in SLS Nylon with the accent pieces printed in Brass with optional plating.
Guidebook Here
Parts
Supported Components
Assembly
Use wire snippers or an x-acto knife to cut the supports from the sides of the switch chassis. This will free the switch chassis and plungers from the main body. Then trim off the support material to free the plungers. The plungers slide into the switch body and should be able to move freely along the guides. You may need to clean loose powder from the switch chassis holes before inserting the plungers. If the plungers are tight, try spinning a drill bit by hand in the holes to clear out any burrs or loose material.
The switch chassis is designed to fit into the clamp section of the hilt and the plungers push tactile switches installed on the back side of the main chassis body.
This is a "Council" (no Masters here) chassis designed to fit the Watto's Junkyard Tusken Slayer (v1 or v2) hilt. This chassis is our highest tier design, the main body is printed in SLS Nylon with the accent pieces printed in Brass with optional plating.
Guidebook Here
Parts
- Main Body - SLS Nylon
- Switch Chassis - SLS Nylon (printed attached to inside of battery slot)
Supported Components
- Proffie v2.2 or GHv3
- 18650 Protected Button Top Battery w/ Keystone Contacts
- 22mm KR Sabers Bass Speaker
- TCSS OLED or Accent Neopixel Strip
- SCW or CCSabers Neopixel Connector
- 3mm standard accent LEDs
Assembly
Use wire snippers or an x-acto knife to cut the supports from the sides of the switch chassis. This will free the switch chassis and plungers from the main body. Then trim off the support material to free the plungers. The plungers slide into the switch body and should be able to move freely along the guides. You may need to clean loose powder from the switch chassis holes before inserting the plungers. If the plungers are tight, try spinning a drill bit by hand in the holes to clear out any burrs or loose material.
The switch chassis is designed to fit into the clamp section of the hilt and the plungers push tactile switches installed on the back side of the main chassis body.
Details
What's in the box:
WJTuskenSlayer_Chassis_NPXLv3
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
