v2.0 FULL SET YUNEEC TYPHOON H480 to DJI prop adap

Modified for better fit. Place the two with the slightly higher center shaft on the arms to the right and left of the Typhoon H. This was done to eliminate prop rub with the 9450 carbon fiber.

One of the adapters has a 3/32" vertical shaft offset to prevent prop rub when using dji 9450. I also added an extra one as a spare.

THESE ARE A TOTAL OF 6 THE FULL SET. If youd like the CW in a different color from the CCW order these two in the color youd like

https://www.shapeways.com/product/EU7HEG7N5/v2-0-cw-yuneec-typhoon-h480-to-dji-prop-adapter?optionId=62077259&li=shop-inventory

https://www.shapeways.com/product/6P97XP9WD/v2-0-ccw-yuneec-typhoon-h480-to-dji-prop-adapter?optionId=62076602&li=shop-inventory

Enjoy feedback is always welcome. So far everyone is happy.

This design reduces the rotational mass and cost of the full set by 26% yet delivers outstanding performance.
It also maximizes the open area above the motor which helps reduce operational temperatures drastically.

This adapter is an expiremental development intended to allow us to use DJI 9443 or 9450 props on Yuneec Typhoon H.


Installation is super simple just remove the factory twist and click system and install these directecly on the motor. Bolts used are pan head Phillips M2.5mm x 6mm. Bolts not included.