Dear Modelers, these are brushless engine mounts I designed for the engines I used in my Schnellboot.
This model needs to be adjusted to the engine being used by you. There are several attributes that needs to be adjusted to make this fit to the engine you are using. The benefit is that the engine is ALLWAYS in line with prophaft and by this you can use a direct coupling between engine and propshaft. These engine mounts needs to be adjusted to the engine you are using, of which I need the following parameters:
- Tube shaft diameter
- Location (dimension in mm) where the screw to mount the engine against the mount are located
- Number of screws being used (sometime you would need only 3 screw in order to put the engine as far as possible to the bottom of the boat.
- Size of the engine
- Size of the direct coupling (diameter, length. Position of screws)