KR Emperor Crystal Chamber Chassis P1

Chassis for the KR x OR Emperor hilts.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

For this chassis you will also require P2 of the design.

This chassis is designed for use with:
-Proffie Board
-KR Sabers 24mm Bass speaker
-18350 Lithium Ion Battery
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
- High amp kill switch
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-18650 battery tabs (see link above for type required)

If you are struggling to get the battery tabs in to the chassis, I recommend heating them up with a clean soldering iron as you insert them. It also helps the plastic form around the tabs to grab them even more.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
The chassis is designed to be fully removable from the hilt, and retained by the pommel.

Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.