White Natural Versatile Plastic
KR Sabers Princess LO Basic Mk3 Chassis R1 GHV3
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$52.43
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the KR Sabers Princess LO Leia hilts.
For this chassis you will also require the R2 Switch House of the design.
With this chassis, you do NOT have to shorten all the screws in the hilt.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-GHV3
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
- ShtokCustomWorx Rotary NeoPixel & 2 Button PCB Connector Set (most likely requires sanding down on the outside diameter)
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
The printed switch housing part is designed to be a goodish fit around the switch assembly of the hilt and correct wire assembly can actually retain this part, but if you still want to add extra security, a tiny bit of double sided tape to the roof you hilt will grab it too.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
For this chassis you will also require the R2 Switch House of the design.
With this chassis, you do NOT have to shorten all the screws in the hilt.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-GHV3
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
- ShtokCustomWorx Rotary NeoPixel & 2 Button PCB Connector Set (most likely requires sanding down on the outside diameter)
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
The printed switch housing part is designed to be a goodish fit around the switch assembly of the hilt and correct wire assembly can actually retain this part, but if you still want to add extra security, a tiny bit of double sided tape to the roof you hilt will grab it too.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
Mk3 GHV3
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
