White Natural Versatile Plastic
Korbanth OWK4 Proffie Basic Chassis
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$49.96
Basic Materials Best Value
Shop Owner Recommendations
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth OWK4 hilts.
For this chassis you will also require P3 of the design.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Proffie
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok neopixel PCB connector set (most likely requires sanding down on the outside diameter)
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Two 4x4x1.5mm SMD micro tactile switches
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
For this chassis you will also require P3 of the design.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Proffie
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok neopixel PCB connector set (most likely requires sanding down on the outside diameter)
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Two 4x4x1.5mm SMD micro tactile switches
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
Jimmy's Lightsaber Junk Korbanth OWK4 Proffie Basi
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
