Korbanth Malgus Basic Verso Chassis
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$62.23
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth Malgus hilts.
You will require the Emitter P3 part to complete this chassis.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Verso
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
The legs of the RCP will need to be trimmed down if you want to install an RCP.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
This design allows for the board to slide into place once wired up and tested. We recommend this as the final step.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
You will require the Emitter P3 part to complete this chassis.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Verso
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
The legs of the RCP will need to be trimmed down if you want to install an RCP.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
This design allows for the board to slide into place once wired up and tested. We recommend this as the final step.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
Jimmy's Lightsaber Junk Korbanth Darth Malgus Vers
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
