FX6 Rugged Mic Holder. Fit Sony ILME-FX6 Camcorder
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$57.81
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This is a custom designed robust yet lightweight microphone mount for the Sony ILME-FX6 camcorder (it will also fit the FS5). It replaces the existing microphone mount and provides a robust and flexible mounting solution for a wide range of microphones with very good vibration and handling noise isolation properties. It is fitted to the camera by unscrewing the two screws that attach the factory supplied mic mount and using the same screws to attach this mount in the same place (do not over tighten the screws).
This mount will take heavier microphones than the standard mount which is prone to becoming floppy and breaking over time.
There are two sets of mounting holes so you can have the microphone at two different distances from the carry handle to suit your individual needs. The microphone mount will not obstruct or block the MI Shoe as many other 3rd party mic mounts will.
This mount will take any microphone up to approx 32mm in dameter. You will need 4 "O" rings to loop over the slots in the mic holder to act as the suspension for the microphone. these should be 2 or 3mm thick with an inside diameter of between 28mm and 32mm (30mm recommended). The O rings will not be supplied by Shapeways, you must source these for yourself. These are very cheap and are normally available on ebay, from car spares stores, plumbing suppliers and DIY stores. If you can't find the right O rings it is also possible to use elastic bands, but these don't tend to support the microphone as well as O rings.
This mount will take heavier microphones than the standard mount which is prone to becoming floppy and breaking over time.
There are two sets of mounting holes so you can have the microphone at two different distances from the carry handle to suit your individual needs. The microphone mount will not obstruct or block the MI Shoe as many other 3rd party mic mounts will.
This mount will take any microphone up to approx 32mm in dameter. You will need 4 "O" rings to loop over the slots in the mic holder to act as the suspension for the microphone. these should be 2 or 3mm thick with an inside diameter of between 28mm and 32mm (30mm recommended). The O rings will not be supplied by Shapeways, you must source these for yourself. These are very cheap and are normally available on ebay, from car spares stores, plumbing suppliers and DIY stores. If you can't find the right O rings it is also possible to use elastic bands, but these don't tend to support the microphone as well as O rings.
Details
What's in the box:
FX6 Mic Holder with logo2
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
