Engine Landing System for Revell Razor Crest Kit

This upgrade is for the engine landing system for the 1/72 Scale Revell Razor Crest, PORT SIDE ONLY. These are seen in the series when the Razor Crest comes into land or coming to a dead stop in flight. The parts were taken from CGI files. There are four parts, two to each nacelle which are numbered 1 – 4. The port nacelle holds the parts 1 and 2, whilst the starboard nacelle holds the remaining 3 and 4. I have placed these as a complete set as well as an option to purchase either the port or starboard sides only.
Modelling skills are needed to fit these parts as the stock part will need to be cut as shown and some sanding will also be needed inside for these to fit in place. Once fitted and glued in place, filling and sanding will also be required.
Instructions
Mark the centre as shown in the illustration, marked “c”. measure 18mm, 9mm either side of the centre line and mark. Measure 15mm across and mark all the way down on both sides of the nacelle. These parts will need cutting away. Some sanding on the inside will be needed as some parts of the inner wall are thicker near the bottom that attaches to the lower half. Once in place, carefully fill any gaps. Once fitted, measure the lower half of the stock part and cut a small section away to fit the remaining upgraded part.
I have also a set of STOL nozzles which will compliment this upgrade.
Link to these are below.
Pitch and Thrust Nozzles for Revell Razor Crest
AMT Versions Coming Soon