Generic Render
Vent Insert - birdhouse wall with hole roof
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$10.56
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This ventillation insert is meant to be attached to a vertical wall of a birdhouse to keep your birdies cooler and dry.
The vent will fit into a 1/2 inch diameter hole in a wall to allow hot air to escape the birdhouse and keep rain out. The vent is attached to a small roof meant to slightly shield the entrance/exit hole from direct rain. Glue the vent in place with a waterproof outdoor glue or caulk.
Use a thin coat of a UV resistant coating or paint on the exposed surfaces to protect the 3D print material from the sun and weathering.
The vent will fit into a 1/2 inch diameter hole in a wall to allow hot air to escape the birdhouse and keep rain out. The vent is attached to a small roof meant to slightly shield the entrance/exit hole from direct rain. Glue the vent in place with a waterproof outdoor glue or caulk.
Use a thin coat of a UV resistant coating or paint on the exposed surfaces to protect the 3D print material from the sun and weathering.
Tags
Consumer ProductsDetails
What's in the box:
7ErAbDbCZIf-wall vent with hole roof
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
