You must be logged in and verified to contact the designer.
Product Description
**50mm maximum can length**
This dual servo plate is designed for a brushless motor. You may need to rotate the sensor plug to the 1:00 O'clock position to clear the plate. The newer motors with flush mount sensor wires work perfectly.
Be sure to clean out the holes. Hand drill only: use a 3/32" drill in the two small holes and 1/8" drill in the front (F) larger holes. Use six (6) M3 nylon lock nuts and 3mm screws. The rear servo mounting holes require at least 12mm long screws. Also, use washers on the plastic side for the servo and winch.
***Do NOT use the rubber or brass harwardware that is funished with your servo. If your servo is plastic remove the gussets as the servo needs to mount flat to the servo plate***
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: