1:8 DeLorean pontoon clips / terminal / split loom (GMQM7FJWW) by 3Dynamics

Marketplace Miniatures SciFi

^{Click and drag to rotate}

1:8 DeLorean pontoon clips / terminal / split loom 3d printed

DIGITAL PREVIEW
Not a Photo

Clear Ultra Fine Detail Plastic

DIGITAL PREVIEW
Not a Photo

Product Description

These set contains a few accurate parts for the right pontoon:

1 x split loom (ribbed hose) that replaces part 83A
3x purple clip including pins. After painting you can just insert the pins in the available holes in the right pontoon. They replace the purple cylinders that come around part 83A.
1x wire terminal that replaces part 83J. I designed the terminal to use it with 0.28mm diameter wire. Attaches to the pontoon by using two pins underneath the terminal. You can also use an MP screw on each end for a more realistic look, if you do, you'll have to drill two small holes of 1.2mm diameter in the pontoon in order to get the screws fully in.
1 x cap to cover the hole in the pontoon on the left side of the split loom

Paints to use:

Tamiya grey primer
Tamiya TS-6 flat black / Vallejo Black 70.950 as base color for the wires terminal and the split loom
Vallejo Steel 71.065 for the metallic parts of the terminal and the purple clips
Vallejo Blue Angel 71.090 for the blue parts mixed with a little bit of Vallejo White 71.119 to make the blue a little lighter
Liquitex brilliant purple for the purple clips
Tamiya X-24 Clear Yellow applied to the metallic parts of the purple clips after you paint them with Vallejo Steel

This set has been designed specifically for the right pontoon of the 1:8 scale Eaglemoss Back to the Future Delorean and has been fully tested by me prior to release.