Base for HyperPixel 4.0 Square Non-Touch

Made by

printminion

Print With Shapeways

Choose Your Material

$209.49

+more

Versatile Plastic
Starting at $ 20.57

Steel
Starting at $ 209.49

Aluminium
Starting at $ 224.94

Multi Jet Fusion Plastic
Starting at $ 20.68

Choose your color and finish

Have a question about this product?

contact the designer

You must be logged in and verified to contact the designer.

Product Description

Enclosure base for pimoroni HyperPixel 4.0 Square Non-Touch* (720x720 pixels (~254 PPI)) and raspberry pi zero.
* it will not fit with HyperPixel 4.0 Square Touch

collection of cases/parts for this screen

Cover is sold separately:

for Pi zero https://www.shapeways.com/product/KX5PLYLCV
for Pi 3 A+ https://www.shapeways.com/product/BC32J366P

Both base and Cover in one color:

for Pi zero https://www.shapeways.com/product/QQ225Z4NP
for Pi 3 A+ https://www.shapeways.com/product/LV7U8J96S

Check out assembly video

You will need a small peace of foam in order to keep display in place.
I used the tesa powerbond (remove protective film only from one side).

WARNING: WHEN INSTALLING HYPERPIXEL 4.0 SQUARE ONTO YOUR PI MAKE SURE NOT TO PRESS DOWN ON THE SCREEN SURFACE! HOLD THE BOARD BY ITS EDGES AND WIGGLE IT TO MATE WITH THE EXTENDED HEADER (OR GPIO HEADER). ALSO TAKE CARE NOT TO PULL ON THE EDGES OF THE GLASS DISPLAY WHEN REMOVING YOUR HYPERPIXEL.

Buy Me A Coffee: https://www.buymeacoffee.com/printminion