Ten4 Short Arm Front Knuckle And Carrier

These are special front carriers and knuckles for the Ten4 Project. They will only work on a short arm car, and are designed to fit the B4 CVA shaft and 1/4" stub axles which will allow you to use full size rear wheels up front. They are made for a 1/4 x 3/8 bearing. The parts needed are Associated 6369 for the 1/4" stub axle and hardware, and 9672 shafts. The set comes with both left and right knuckles and carriers.

 

While there is no reason you couldnt use a complete B4 CVA set (which comes with a 3/16 axle) and 3/16 x 3/8 bearings, this has not been tested.