You must be logged in and verified to contact the designer.
made for a Zspar Z230 feed slot cut of 75mm x 13.5mm
Tom Luque info@MastGates.com
This insert was made without the extended side barbs so you will first test the geometric fit within the channel and how well it seats. Put in a sail slug and try to pull it out. How well did it hold?
Send photos from 30mm away and at different angles so I can see into the channel and sides.
If for any reason Shapeways will not let you order, send me your address for processing it for you.
Place a 1/16" drill bit in drill guide hole of nipple pin.
Center insert within the feed slot.
Strike the drill bit to mark the back web of the channel.
Remove the insert and drill a 3/16" into the marked location.
To remove metal burrs, use a slightly larger drill bit to hand turn over the hole to smooth edge.
The insert can now be installed and the nipple pin will prevent the insert from sliding.