Universal Chassis-40mm Steer (INL,S/Can,Flgd bush)
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$26.50
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Universal Chassis-40mm Wide Steering Front End
- Rear uses flanged bushes (Slot It PA02)
- Takes a 'S-Can' motor, Endbell drive (inline config.)
- Chassis width 44mm, can be trimmed down to 26mm.
- Rear ride height adjustment of 1.5mm, using M2 grub screws.
- Wheelbase 95mm (max) & 58mm (min) after trimming.
- Space for Slot It Magnet (CN06), which may need to be stuck down.
- Screws needed: M2.2 screws for Body posts, rear axle brackets & fixing nuts. M2 grub screws for ride height adjustment.
- Screw set needed for front end assembly, available in the “Parts - JA Slots” section,
click here. (Parts include: 3x M2.2x12mm Screws, 2x M2.2x6mm Screws, 2x 12.5mm Stub Axles(3/32) in Steel, S/S or PA12).
- Washers can be assembled above or below the hubs for some height adjustment.
- Motor wire fixing under the front axle.
- Some trimming may be needed due to the nature of 3D printing.
Parts Included:
1x Front Steering End
1x Left & Right hubs
1x Bracket Arm
1x Guide
2x 1mm Washers
1x Rear End
2x Rear Axle Brackets
2x Fixing Nuts
2x Body Posts
General Material Notes:
Colors are slightly more flexible then Black, White is slightly more flexible then colors.
(Ref: JA55)
- Rear uses flanged bushes (Slot It PA02)
- Takes a 'S-Can' motor, Endbell drive (inline config.)
- Chassis width 44mm, can be trimmed down to 26mm.
- Rear ride height adjustment of 1.5mm, using M2 grub screws.
- Wheelbase 95mm (max) & 58mm (min) after trimming.
- Space for Slot It Magnet (CN06), which may need to be stuck down.
- Screws needed: M2.2 screws for Body posts, rear axle brackets & fixing nuts. M2 grub screws for ride height adjustment.
- Screw set needed for front end assembly, available in the “Parts - JA Slots” section,
click here. (Parts include: 3x M2.2x12mm Screws, 2x M2.2x6mm Screws, 2x 12.5mm Stub Axles(3/32) in Steel, S/S or PA12).
- Washers can be assembled above or below the hubs for some height adjustment.
- Motor wire fixing under the front axle.
- Some trimming may be needed due to the nature of 3D printing.
Parts Included:
1x Front Steering End
1x Left & Right hubs
1x Bracket Arm
1x Guide
2x 1mm Washers
1x Rear End
2x Rear Axle Brackets
2x Fixing Nuts
2x Body Posts
General Material Notes:
Colors are slightly more flexible then Black, White is slightly more flexible then colors.
(Ref: JA55)
Details
What's in the box:
SPW-Uni-Inl_S-Can-FB-Chassis-40mm-St-Front
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
