7 pairs eyelids 7.5° for 27mm cartridge eyes

Eyelids for TPE or silicone dolls with cartridge eyes.

• Designed for cartridge eyes with a 27mm cartridge.
• Only 0.5mm thin.
• Can be painted with makeup or acrylic paint.
• Doll eyelashes or normal eyelash can be glued on.
• Magnetic eyelashes can also be used. (Symply glue on a thin wire)
• In this set are 7 pairs of eyelids with the curvatures 7.5°. (Also aviable with 3 pairs / 0° or 15°.)

How can I decide which curvature fits best?
Every doll's eye is different. To ensure the best possible fit, I offer different curvatures.

• 0° If the upper and lower eyelids have approximately the same curvature.
• 15° If the upper eyelid is more curved than the lower eyelid.
• If you can't decide, take the "tryout" set with 0° , 7.5° and 15°.

(The angle refers to the cutout vertical to the eyelid surface in the center. The greater the angle, the greater the curvature)

Adjusting the eye width.

• To adjust the eyelid to the width of your doll's eyes, remove the eye cartridge from the head.
• Then measure the width of the eye opening with a caliper.
• Now place the caliper on the corner of the eyelid. (see picture)
• Mark the spots with a light-colored marker or scratch it with a pointed object.
• You can then trim the eyelid with nail scissors. (like the red lines in the picture)
• Then sand down the corners.