1977 L2 Gleaner

1977 L2 Gleaner

 

Tires drive, 23.1-34, 24.5-34,30.5-34,  

steer tires, 11L-16, 

corn headers, 830,630,538,438

Flex headers, 22, 20,18,16,15,13.............   22,18,15 are available,

Rigid headers, 24,22,20,18,16,15,13         24, 20 and 15 are available

 

there are cage frames on the side, small screen if you have it would work great for the cages.

 

paint recomended,

aluminum best copies galvanized,  and flat aluminum looks like it was sitting in the weeds for 10 years.

white for fuel tank, black for most of the frame

 

Assembly is required and would recomend to have handy,

Dremyl, sand paper, files, exacto knife, drill bits, needle nose pliers, small guage wire, 22 to 26 guage. wait for kit to show up before getting wire to please your preference.

 

 

From the top down on the front,  everything on this bar would be black in color, except the cab depending on the model and same with interior. paint then snap off for easier painting

1. rear axle, plug into hole under the tail

2 front axle, plug into the 2 holes under where feeder house goes. make sure axle hubs are up, not down, the combine should smile when assembled.

3 back folding ladder for catwalk

4 pins for front axle to hold wheels on

5 mirrors, holes pre drilled in cab

6 Feeder House, you can attempt at using supplied pins, 1/16 inch hole , brass rod recomended or any other stronger piece.

7 ladder

8 cab

9 cab interior

 

The piece on the bottom is the Return elevator top and bottom piece that hook up to the feeder house and the return elevator that goes out the front.

And out front the unload auger which needs a 1/16th pin