XT4_FrontArm_V3

Arms modeled after the arms on the XB4, but with shock locations that match the XT4 geometry.  The rear of the arm has also been extended 2mm to eliminate the 2mm shim as used on the XB4, to give more strength at the inner hinge pin.  Also correctly locates the sway bar link for proper angles when using XB4 sway bars.  

*Note- Sway bars can be mounted using either XRAY 302656 Alu Ball End (threaded) and 303454 Composite Ball Joint with an M3x8mm screw, or you can use a lower shock eyelet and ball, XRAY 368010 and 352460 with an M3x14mm screw.

*Note- these arms use the XB4 outer front hinge pin, which are retained by a grub screw in the bottom of the C-Hub.  This was done to eliminate the small holes for 2.5mm screws to capture the hinge pin, which yields more strength.  

Sold individually, so you need to buy 2 arms.  They are identical side to side.