Natural Bronze
Korbanth OWK4 Crystal Chamber P4
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$78.53
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth OWK4 hilts.
For this chassis you will also require P1, P2 & P3 of the design.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Proffie Board or GHV3 (depending which P1 listing you purchase)
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok neopixel PCB connector set (most likely requires sanding down on the outside diameter)
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-128x32 OLED screen (depending which P2 listing you purchase)
-Offcut on neopixel strip
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing in to the chassis before fully assembling and gluing the chassis.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
For this chassis you will also require P1, P2 & P3 of the design.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Proffie Board or GHV3 (depending which P1 listing you purchase)
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok neopixel PCB connector set (most likely requires sanding down on the outside diameter)
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-128x32 OLED screen (depending which P2 listing you purchase)
-Offcut on neopixel strip
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing in to the chassis before fully assembling and gluing the chassis.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
OWK4 P4 New
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
