White Natural Versatile Plastic
Korbanth Malgus Crystal Chamber Chassis Emitter P4
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$20.38
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth Malgus hilts.
This is a permanent wired in battery design, not removable.
You will require parts P1, P2 & P3 to complete this chassis.
This chassis is designed for use with:
-Proffie or GHV3 (depending which P1 listing you purchase)
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Two Crystals or two of my Generic Kyber Crystal parts, available on shapeways, each with single neopixel
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
This install is not for the faint of heart, lending itself to true masters of installation, with experience, knowledge and time to achieve one of the best looking 3D printed, double crystal chassis for this hilt.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then a crystal requires gluing into the chassis and the other into the chamber part once everything is wired up and tested.
Once everything is checked and the crystals are glued in place, the main crystal chamber can be fitted in to the main chassis. Finally assembling the battery between the main chassis and P4, wiring through to the emitter PCB and the switches.
This design allows for the board to slide into place once wired up and tested. We recommend this as the final step.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
This is a permanent wired in battery design, not removable.
You will require parts P1, P2 & P3 to complete this chassis.
This chassis is designed for use with:
-Proffie or GHV3 (depending which P1 listing you purchase)
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Two Crystals or two of my Generic Kyber Crystal parts, available on shapeways, each with single neopixel
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
This install is not for the faint of heart, lending itself to true masters of installation, with experience, knowledge and time to achieve one of the best looking 3D printed, double crystal chassis for this hilt.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then a crystal requires gluing into the chassis and the other into the chamber part once everything is wired up and tested.
Once everything is checked and the crystals are glued in place, the main crystal chamber can be fitted in to the main chassis. Finally assembling the battery between the main chassis and P4, wiring through to the emitter PCB and the switches.
This design allows for the board to slide into place once wired up and tested. We recommend this as the final step.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
Malgus Emitter P4
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
