Gray PA12
Korbanth Fisto Basic Chassis Proffie
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$101.13
Basic Materials Best Value
Shop Owner Recommendations
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth Fisto hilts.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Proffie Board
-KR Sabers 24mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Two single pixels for the accent lights
-Two 4x4x1.5mm tactile switches
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Proffie Board
-KR Sabers 24mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Two single pixels for the accent lights
-Two 4x4x1.5mm tactile switches
This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
JimmysLightsaberJunk Korbanth Fisto Basic Proffie
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
