You must be logged in and verified to contact the designer.
Product Description
Universal Chassis-40mm Steer (INL,Slim,Flgd bush) - Rear uses flanged bushes (Slot It PA02) - Takes the slim can motor (Shaft lengths 8, 10 & 14mm) (inline config.) - Chassis rear width 24mm. - Rear ride height adjustment of 1.5mm, using M2 grub screws. - Wheelbase 95mm (max) & 62mm (min) after trimming. - Screws needed: M2.2 screws for Body posts, Rear axle brackets & fixing nuts. M2 grub screws for ride height adjustment & mounting motor brackets. - Motor bracket #1 used for front of motor & bracket #2 used for rear of motor. - Slim motor with 8mm shaft uses set of holes closest to axle. - Slim motor with 10mm shaft uses set of holes 2nd closest to axle. - Slim motor with 14mm shaft uses set of holes furthest from axle.
- Screw set needed for front end assembly, available in the “Parts - JA Slots” section, click here. (Parts include: 3x M2.2x12mm Screws, 2x M2.2x6mm Screws, 2x 12.5mm Stub Axles(3/32) in Steel, S/S or PA12). - Washers can be assembled above or below the hubs for some height adjustment. - Motor wire fixing under the front axle. - Some trimming may be needed due to the nature of 3D printing. Parts Included: 1x Front Steering End 1x Left & Right hubs 1x Bracket Arm 1x Guide 2x 1mm Washers 1x Rear End 2x Rear Axle Brackets 2x Fixing Nuts 2x Body Posts General Material Notes: Colors are slightly more flexible then Black, White is slightly more flexible then colors. (Ref: JA90)