You must be logged in and verified to contact the designer.
Product Description
Elite-Chassis for 89sabers Windu
Holds a prewired 18500 Li Ion battery (protected). Lock down with chassis cap.
The crystal chamber has a dedicated channel to lead the wires to the board and RCP location.
Switch- and LED-wires can be placed in the remaining space. Feed them right into the flat wire channel of the chamber.
There are 2 locations for 2 neodym magnets (round 4x1mm) to be glued in there. Be sure about the polarity of the magnets of the front crystalholder where the other 2 magnets are glued in.
Hilt mounting: Drill a hole and tap a thread (m3 or similar inch) 15mm behind the switchholder cutout. Make sure you place the hole centered behind the middle button. A 3mm long setscrew holds the batteryholder in place. Don't drive in too deep in order not to damage wires or battery. You may need to cut your setscrew a little shorter.
Features:
-Plecter Labs Prizm V5.1
-18500 LI-Ion Battery
-2x 3mm accent LED
-crystal chamber
-1x 5mm crystal LED (rgb for violet)
-24mm bass speaker
-28awg wire required (0.09mm² cross section) / 0.25mm² cross section for battery and LED positive
-quick connector RICE port (2.54mm grid)
-2.1mm rechargeport
-snappers for 2W resistors (5mm OD)
Full assembly requires follwing parts to be purchased seperately by yourself:
-4x neodym magnets (round 4x1mm)
-set screws m3 thread or similar inch thread (2x 6mm long, 7x 4mm long, 2x 3mm long for chassis and heatsink retention)
-2.54mm grid connector (3 pins) for RICE
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: