You must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth Crimson Menace hilts.
This is a permanent wired in battery design, not removable.
For this chassis you will also require P3, P4, P5, P6 to complete the chassis.
P7, P8, P9 & P10 are optional accent parts that can be painted and glue to your chassis if desired.
This chassis is designed for use with:
-Two Proffie Board
-Two KR Sabers 24mm Bass speaker
-Two 18650 Lithium Ion Battery
-Two High Amp (6A) 1.3mm recharge port
-Four metal 4x4x1.5mm SMD tactile switches
-Two Crystals or my generic chassis crystal (found on shapeways) and two single neo pixels
-Shtok neopixel PCB connector set (most likely requires sanding down on the outside diameter)
-Two Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
Plan your wiring ahead of time!
The speakers are required to be wired in and inserted first before the crystal chambers (P5 & P6) are inserted. Make sure the speakers are fully inserted and secure.
The recharge port requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
This design allows for the board to slide into place once wired up and tested.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: