89 Sabers Graflex 2020 Crystal Chamber Chassis P3

Chassis for the 89 Sabers/Korbanth Graflex 2020 style hilts (Graflex Supreme & Reyflex).
This is a permanent wired in battery design, not removable.

For this chassis you will also require P2 & P3 of the design. Two variants of the P3 are available.

This chassis is designed for use with:
-Proffie Board
-128x32 OLED screen (two P3 variants are available to purchase, non OLED & OLED) 
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm x 5.5mm PCB laptop style recharge port (rectangular front)
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-KR blade magnet

The recharge port requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing into the chamber once everything is wired up and tested.
The crystal chamber required gluing onto the main body when ready and wired through. 
The chassis is design for the board to slide into position once tested. We recommend this as the final step. 

Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.