Structure Sensor Bottom Cover w. Magnets

The replaces the bottom cover of your Structure Cover with one with three rare-earth magnets that provides a superb adhesion to any ferrous surface.  This works in conjuction with several NEODiMOUNT version 2 cases and brackets, as well as the NEODiVR "Stealth" iPhone bracket. This allows you quckly to use the same sensor on a number of iOS devices.

Note: You need three i/2" diameter 1/8" thick rare-earth magnets.  These should be inserted into each cavity so they are as flush as possible with a thin layer of contact cement appied to the south pole surface, and on the cavity surface of the bracket. Once inserted, use clamps with firm pressure, and wait the recommended time for the adhesive to cure.

Then remove the four torx screws holding the current bottom in place, then using a spug or thin plastic wedge , gently apply pressure between the edge of the case & and bottom along the center to release the 2 clamp like latches built into the bottom.  Then lift the bottom piece up and away from the sensor.  Take care to not touch any of the components inside and place the new bottom (with magnets already attached) in place.  Gently press down on the sides to latch the sides and then screw in the existing four Torx screws without over tightening.

NOTE:  This will void your warrantly.  Owl Creek Technologies assumes no repsponsibility for any damage during its installation.