Solo's Hold Blind Knight Basic Proffie Chassis P1

Chassis for the Solo's Hold Blind Knight hilts.

For this chassis you will also require P2 of the design.

This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

This chassis is designed for use with:
-Proffie
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Two 3mm LEDs
-Two 4x4x1.5mm  metal SMD  tactile switches

This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.
The P2 speaker press part is designed to be slightly taller than actually required. File down the bottom of the P2 part to suit your hilt.

Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.