Beer Can Wifi Booster

There is currently a Kickstarter campaign here​ ---> https://goo.gl/wcai2o

My years running my own business as computer technician, & not a little patience ;-), have produced this design. The plastic arm I have made fits a beer can perfectly & allows for parabolic adjustment according to your needs. I have built the prototypes you see here, on my 3D printer. The next step is getting a metal mould cast so I can mass produce them at a low cost I can pass on to the consumer. (The 3D printer works fine but takes 35 minutes to make each one!)

Also, thanks to the clip, it can be placed on the antenna, guided or removed with a single move.

Many weeks and dozens of prototypes have been thrown in the trash before I managed this final design which, even if I say so myself, is PERFECT!.

I am using one myself in the office & everyone who comes in, wants one, I have decided to start a cottage industry to offer them Online, & world-wide.

The improvement in my case, has been a full 300%. 

Use cases:

I have to say this booster only improve signal of alreaddy connected networks, don´t expect to discover new networks (It's possible but not warranted).

Depending on your situation two boosters will work better than one—one for the router & the other from the receiving terminal. Below, some typical cases

Case 1: the router is far away.

For example, when is one floor or room between your adapter and router or you want connect better with the garage. Normally you only need one booster fixed in adapter’s antenna aiming to the router or fixed in the router aiming to the desired zone.

The kit attached to the adapter's antenna

Case 2: the router is far away.

The distance is greater, like a workshop in the back garden, or a garage that isn't attached to the house et al. Here, two boosters aiming to eachother might serve your needs better.

Beer Booster attached correctly to the antenna's router

The kit consists of what is pictured below. You will receive one unit along with my sincere gratitude.