KR Sabers Princess LO Crystal Chamber Chassis P1

Chassis for the KR Sabers Princess LO Leia hilts.

For this chassis you will also require P2, P3 & P4 of the design.

With this chassis, you do NOT have to shorten all the screws in the hilt. The only two screws you need to reduce the length of are the two that will be infront of the battery when the chassis is inserted.

This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

This chassis is designed for use with:
-Proffie Board
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp kill switch
-Shtok 10 pole PCB connector set (most likely requires sanding down on the outside diameter)
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel

This design allows for the board to slide into place once wired up and tested.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing in to the chamber before fully assembling and gluing the chassis.
If you struggle inserting the battery tabs, I suggest carefully warming the tabs with a clean soldering iron as inserting them. It will help for the plastic surrounding the tabs to grip them.

Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.