This is a
pair of CB/ham radio microphone hangers designed to fit the revival 2nd-gen Toyota Tacoma
threaded accessory mounts made by
Coop68 on Tacomaworld. If you've got a pair of the
new threaded mounts (not the originals by Lostsheep), then these mic hangers will fit your mounts.
There's two models available - this is the "low" model utilizing the bottom threaded mount point only, leaving the top two threaded mount points available for a RAM ball or anything else that can utilize a 1/4"-20 hole. The other model, slightly higher, is here.
Each hanger requires a single 1/4"-20 socket cap screw, 1/2" long, to attach to the mount. I use
these from Fastenal. The mic button cradle is intended to point outboard to leave as much access as possible to the climate controls.
The tolerances on the screw holes are very tight - thread the screw in to the mic hanger to start, then place the mic hanger on the threaded holes and tighten the screw until snug.