Small Case Base for Small Futhark Runes

This is the base of the case for the Small Futhark Runes. The lid is also needed to hold the Runes effectively.

The design of thie case is themed to work with the Rune Designs. 

The lid snaps into place on each end of the base. Just hook the lid on one side of the base, then lower the other side, and lift the end over the 'catch'. The lid is plastic, and will flex a bit to allow this. 

The result, is a firmly closed lid, holding all Runes together in place. 

The Lid of the case has the "Futhark" spelled out on it, using the runes to do so.

The open design of the case was created:

1) Because its fun

2) To allow you to see the Runes inside

Note: It is possible to use Spray Glaze to provide a shiny surface to your 3d Printed Parts.