1/600 HMS Ajax Bridge Upgrade (With Hatches)

Highly detailed 1/600 HMS Ajax bridge upgrade set for the 1/600 Airfix kit.

• Highly detailed part, printed with POM POM Directors, Bridge Binoculars, Officers chairs and Binacle.
• Very accurate, modelled off plans and photographs
• Printed with small guides for photo etch railing.
• Printed with hatches in place, cuts down on cost of Photo etch.
• Other option available in my shop (without hatches).
• HACS MKIII, Main director and Range Finders not included (see HMS Ajax section in my shop for these.) These items are for sole use with this bridge set.
• Coming soon Lower bridge superstructure and Aft superstructure.

NOTE: This model has been made with the bridge hatches and door hatches in place. In case modeller wishes to add photoetch and or have window hatches open then please purchase the other bridge set available in my shop.
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process.  Although the parts are cleaned by Shapeways, some waxy residue may remain.  It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners.  Customers report that "Bestine" and "Goo Gone" also work well.

During the printing process, liquid resin is cured by ultraviolet light.  Microscopic bits of resin may remain uncured.  Let your parts sit in direct sunlight for a few hours to fully cure the resin.  

Water-based acrylic paints meant for plastics is strongly recommended.  Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.

Use dedicated model sprue cutters to remove parts to minimise damage to parts.

Please take a look at my other items.