Prizm Proffie Saberforge 28/1.1" RB 18650 Chassis

This is a 28mm/1.10" x 87mm/3.43" chassis with removable battery provision for use in any saber with that diameter, such as the regular Saberforge line. This fits in basically everything Saberforge makes except for shotos I'm working on something for that.

Features specific to this chassis include, but are not limited to:

• Placement for a removable protected 18650! All other chassis in this size category use a fixed 18650, necessitating a recharge port. However, for long days trooping or training, charging up a battery from a port can take way too long. Being able to hot-swap batteries is the best solution, especially with high-drain setups that use Neopixel.
• CHANGED! Under-side recess of 67mm x 20mmish, for mounting your primary sound/effects board. It's bigger than the one on my old version!
• INFORMATION UPDATED! Yes, it fits the Plecter Labs CRYSTAL FOCUS X board! Sorry for not updating.
• NEW! Now fits Plecter Labs PRIZM 5.1/5.5 and the ProffieBoard in its single-board format!
• Retains the ability to fit Plecter Labs Pico Crumble and Nano Biscotte v3/v4 + PEX along with the 7Chambers CoreFX/Spectra boards
• NOT COMPATIBLE WITH CRYSTAL SHARD 9 OR LOWER, CRYSTAL FOCUS, OR ANY NAIGON BOARDS  Please don't try and fit any of them in here. It won't work. If you do this and you blame me you're wrong.
• NOT COMPATIBLE WITH THE TWO-BOARD VERSION OF THE PROFFIEBOARD 
• NOT COMPATIBLE WITH NANO BISCOTTE V4.1 why are you getting this if you have a 4.1
• Mounting ring with 10mm depth and two cutouts for any 28mm speaker of your choice! Also compatible with Railmaster 27mm. You may have to sand down the speaker cutouts a bit, but all aforementioned examples worked fine on the test mounting.
• Glue channels along the left and right sides of battery holder to hold stuff in.
• Wire channel underneath battery holder

You will need to purchase a Keystone 1042/1042P/1043 battery holder from an appropriate vendor, such as Digi-Key, Mouser, or TCSS ("18650 single cell holder" from them). Upon receiving the holder, you're going to have to cut off the plastic nubs sticking off the bottom. (A future revision may have mounting holes but don't hold your breath.) Before you finish your installation, you're going to have to glue it to the chassis in order to ensure a steady installation using the provided channels. High-temperature hot glue is my recommendation because it's a really strong space-filler, effectively acting as a thermoplastic.

In addition, your speaker is also going to need glue in the appropriate location/s. 27mm/28mm speakers will absolutely protrude from the end of the chassis, and will add anywhere from 3mm-5mm of overall length due to speaker vibration headspace.

Yes, I'm leaving the old revision up specifically for NB/PEX/Pico setups because it's a bit more snug with the smaller boards in it. This entire paragraph is a link to that version of the chassis! You can still use this one with NB/PEX/Pico if you'd like though.

also known as MiriSpine v1.1