1/87th Heavy Semi Truck Lift for Repair shop

This four post heavy truck lift is designed to raise and lower semi truck tractors for truck shop mechanic work. The main platform is able to move up and down, and can be pinned in place if the owner/builder decides to do that by drilling a small hole to fit a pin into one of the posts should you desire that. Otherwise it can be glued i any position your prefer. The platform is a little over 26 scale feet long, with ramps that sit on the concrete for the ends.  Each rail is a scale 28" wide, with plenty of room for a semi to drive through the posts. Best results for placement in a shop would be to clean all the parts, paint them and then slide posts over platform supports and set in position. You can then glue the base down to the surface and place the risers in position on either end. You can also leave some of the sprue attached to the base of the platform and drill a matching hole for additional support.  Should there be a question or concern, contact me via the designer link or direct via email to modelmechanic@gmail.com