4X Axial SCX10 Shock Spring Perch

These replacement spring perches replace the stock slotted perches for most Axial SCX10 Shocks. This allows the spring to thread onto the perch, and is a tight fit to the rod end to prevent the perch from coming off and getting lost. 

To install:

1. Remove the spring, axial spring perch, and rod end from the shock shaft.

2. Thread the spring onto the JCAD Spring Perch.

3. Put the spring back onto the shock, and reinstall the rod end on the shock shaft.

4. Press the JCAD Spring Perch onto the rod end. The fit should be pretty tight to lock the perch into place. (Can be removed later if shock maintenance is necessary though.)

Note: The part comes on a part tree, and each piece will need to be removed from the tree. This may leave a white dot where the tree connected to the part.