Basic Nylon Plastic
rc1101-01 RC10 Rear Bulkhead
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$22.11
Basic Materials Best Value
Shop Owner Recommendations
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This bulkhead is to be used with the rc1102-01 RC10 Battery Retainer to allow a standard 2S Lipo hard case to fit into the RC10 chassis. If your lipo has vertical battery wires (one + and one - as well as the center balance wire) that come up front the end of the lipo, this will allow you it to fit but not with the ESC plate (printed parts are pre-production and do not have these notches for the wires).
NOTE: This has only been tested on our vintage A-Stamp chassis and one Black chassis car. If there are variations to the mounting holes, we are unaware. Check the video and reach out prior to purchase if you have any concerns.
Image of MJF printed version is for reference as the updated one has 3 slots for bullet connectors
NOTE: This has only been tested on our vintage A-Stamp chassis and one Black chassis car. If there are variations to the mounting holes, we are unaware. Check the video and reach out prior to purchase if you have any concerns.
Image of MJF printed version is for reference as the updated one has 3 slots for bullet connectors
Details
What's in the box:
rc1101-01_1-1_rear_bulkhead
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
