Axial Yeti Motor Mount

This is a custom built motor mount the will allow a 41mm diameter, 75mm long motor be installed in an Axial Yeti without having to cut a section out of the battery tray. (The battery tray will have to be filed down for the sensor cable if you are running a sensored motor, but you will not lose any space in your battery tray.) I have tested this motor mount on up to 6S and was not able to break it and the material will hold up to the heat of an RC motor.

These are all standard RC hardware sizes, so you probably having these sizes laying around if you work on RC cars a lot. This motor mount is not compatible with the stock clutch system. You WILL need the following hardware and parts to install this motor mount:
5- M3x12mm Socket head screws
3- M3x6mm button head screws
2- 3mm ID, 7mm OD flat washers
1- M3x12mm Countersunk screw
1- Traxxas 5556 Pressure Plate
1- Traxxas 5352R Clutch Rebuild Kit
1- Traxxas Spur gear (of your choice)
1- Traxxas Pinion gear (of your choice)