You must be logged in and verified to contact the designer.
Product Description
Falcon cockpit for the DeAgo kit
I've designed a complete cabin cockpit to replace the stock one composed by the main consoles and four seats.
On this product you will receive one -1- cockpit composed by one main console, two pilot seats and two nav seats -that are smaller than the stock ones, that are too big-.
This cockpit has the size to fit inside the cabin tube, but you will have to trim a little bit the rounded tab of the tube of the DeAgo Falcon. My cabin cockpit is designed to enter deeper on the cabin tube than the stock one. So you must sand the two side tabs inside the cabin tube to fit my backwall and the long cabin.
This upgrade it's a very close replica from the cockpit seen on the studio filming model. It has all the little details. I've designed it to allow fiber optics lighting or you can put a led under the console, on the built in bottom hole, and play with the unpainted surfaces for lighting effects.
The main console has built in pre drilled holes for fiber optics too -0.25 mm-.
This product has been designed to fit the cabin walls and cabin cone that you can find in this shop. This cockpit is not intended to be installed with the stock cockpit of the DeAgo kit. Do not buy it if you aren't an advanced modeller.
You can find the cabin walls and cabin cone that fit this cabin cockpit on these links, and you can buy also the side consoles:
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: