This is a Enroute Berg front case including servo mount. Its motor is mounted on the opposite side of normal berg. Choose carefully before you order it. It requires the following parts to complate the front axle:
- Gear - Stock, RCBro, RC4WD. Not Dlux SAF gear (both STD or Low Ratio) as the large second wont fit.
- Tube - 12mm OD tube, it can be made with Aluminium, CF, Delrin, or mixture of materials to achieve the characteristics you are after;
- Upper Link mount - make your own using CF or ally plate.
- Lower link mount - any of the tube link mount for 12mm OD tube would be fine.
- C-Hub - if you want to use AR60 spline, I will have an adaptor for it. If you want to use AX10, just wrap the 12mm OD tube with a single layer of 0.5mm ally (or brass) sheet and the AX10 chub will fit snugly and secrued it with 2 screws like usual.
- Knuckle - Depends on the chub you choose.
- Shaft - adjust the length of the tube to get the desire width and stye of shaft.
This is
NOT a bolt on option, it required some fabrication and skill to make it all fit.
This Berg Front Case created by Jayden Hocking. I am just selling this on behalf of him.