AtomSabers Depa Billaba Crystal Chassis Proffie P1
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$50.84
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the AtomSabers Depa Billaba version hilts.
This is a permanent wired in battery design, not removable.
For this chassis you will also require P2, P3, P4 & P5 of the design.
This chassis is designed for use with:
-Proffie Board
-KR Sabers 22mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-Offcut of pixel strip to light up the vents in the cover
-8-off 2diax2mm neo magnets
-4x4x1.5mm SMD tactile switch
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
This design allows for the board to slide into place once wired up and tested.
8-off neo magnets are required to be glued into P5 to match the magnets in the relating part of the hilt. Make sure you check your magnet origentation before gluing anything.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires being glued into the chassis with the chamber parts glued over the top after the chassis is installed and in the hilt.
The board & RCP are accessible through the pommel. I recommend never over tightening the pommel.
Any damage occurred during installation is the responsibility of the individual installer.
This is a permanent wired in battery design, not removable.
For this chassis you will also require P2, P3, P4 & P5 of the design.
This chassis is designed for use with:
-Proffie Board
-KR Sabers 22mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-Offcut of pixel strip to light up the vents in the cover
-8-off 2diax2mm neo magnets
-4x4x1.5mm SMD tactile switch
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
This design allows for the board to slide into place once wired up and tested.
8-off neo magnets are required to be glued into P5 to match the magnets in the relating part of the hilt. Make sure you check your magnet origentation before gluing anything.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires being glued into the chassis with the chamber parts glued over the top after the chassis is installed and in the hilt.
The board & RCP are accessible through the pommel. I recommend never over tightening the pommel.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
New Depa Proffie
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
