Will this print in Full colour Sandstone?

Discussion in 'Technologies and Hardware' started by paulelderdesign, Apr 3, 2013.

  1. paulelderdesign
    paulelderdesign New Member
    Hi guys I made a pendant for my store and had to make the thickness of the main body 2mm although not game accurate it was the min I could do. However I'm a little worried about the 0.6 mm extrusions that make up the seperate details. Simple question will it print? if not how can I mod it? :confused

    Thanks

    Paul
     
  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    The part I'd be worried about is your pillars in the center. They look really small. For details, they can't be longer than they are wide.
     
  3. paulelderdesign
    paulelderdesign New Member
    I thought that. I was going to leave them out altogether as it's game inspired art. I noticed that there is a few distortions in the mesh too so once I get that sorted I can try and print it :)

    Paul