Scaling if you're using Wings3D

Discussion in 'Software and Applications' started by lensman, Mar 23, 2010.

  1. lensman
    lensman Well-Known Member
    If you use Wings3D (and I haven't seen many people mention it here) then you are likely aware of how difficult it is to scale to an exact size. I have uploaded a model to test this and have found that one square on the Wings3D grid equals 2.5cm.

    When uploading to Shapeways you must check off the scaling size as inches, NOT millimetres.

    You can see the test model here.

    http://www.shapeways.com/model/105244/oval_size_test.html