Need designer to "hollow out" 3D files

Discussion in '3D Design Requests' started by 535852a7fa, Jan 17, 2012.

  1. 535852a7fa
    535852a7fa New Member
    Greetings Shapeways members,

    I am considering getting 3D scans of prototype wargaming miniatures produced through Shapeways.

    I am pretty sure I can handle the process of getting the models scanned but I will need help on getting these files print ready, which will include hollowing them out to save cost.

    Is there a designer here that would work on a per model basis. I am trying to figure out what the cost would be for this service.

    I can be reached at jodeebenavides@yahoo.com

    Best regards,

    Jodee
     
  2. Twopounder
    Twopounder New Member
    I'm not quite at the point where I can claim to be a great artist, but there a modeler named John Bear Ross who specializes in this kind of stuff. You can contact him at johnbearross@gmail.com or check out his site at http://johnbearross.com/.

    Good luck!