Key Needed

Discussion in '3D Design Requests' started by mehrdada, May 10, 2013.

  1. mehrdada
    mehrdada New Member
    Hello everybody!

    I need a exact copy of my key made. I can even send the key to you if it helps make it a better 3D model. If the first one turns out good, I will pay you again for another key that is the type of key.

    I've attached some photos to the type of key it is but its not the actual key. The key is the same brand and same model. Just want to figure out if its possible. Thanks

    I forgot to mention I will pay anywhere from $50-$100 per key model.


    Last edited: May 10, 2013
  2. CADNinja
    CADNinja Well-Known Member
    Why dont you just go to the hardware store to get a copy made??

    Otherwise this would need to be scanned in and that alone would be over $100
  3. stonysmith
    stonysmith Well-Known Member Moderator
    Rather obviously, the "Do Not Duplicate" would scare off most designers.

    Beyond that, if you want a functional key, I'm not sure that the Stainless Steel material would be precise enough to work properly.
  4. CADNinja
    CADNinja Well-Known Member
    Ah... Did not see that. Entire posting and threads should be removed