Designer for Corbels for door frame.

Discussion in '3D Design Requests' started by pablo, Jul 20, 2013.

  1. pablo
    pablo New Member
    I am getting a door and frame made up to match a neighbour's door. I want to get the corbels3d printed similar to what he has.

    I know Ideally I would need to remove one of his corbels and get it scanned in 3d scanner but this is not possible.

    If I was to photograph from front and side and give dimensions would someone be able to create a close replica which I can then go and organise a 3d print of? Or is there a special camera I should use / get someone locally to operate?

    Would suit someone in Dublin, Ireland or perhaps a design is achievable from any location (once certain action is done at this end).

    Any suggestions welcome.

    thanks,
    Paul.
     

    Attached Files:

  2. sorhain
    sorhain New Member
    I sent a pm
     
    Last edited: Jul 20, 2013