Calculation is off?

Discussion in 'Design and Modeling' started by Caponata, Jun 10, 2010.

  1. Caponata
    Caponata New Member
    I uploaded a project I'm working on and have some questions about it. The object itself is hollow, it's a case for a device I'm working on. However I think the Shapeways system seems to think it's a solid object and the price is like $1400 for a 9"x9"x3.25" hollow object. Am I missing something here?

    I was kinda expecting it to cost less as 938cm3 is a little much. Any ideas?
  2. joris
    joris New Member
    Mmmm...Houston we might have a problem. Could you email your file to service@ so they can take a look at it.

  3. Caponata
    Caponata New Member
    Email is sent, haven't heard back yet.
  4. gibell
    gibell Well-Known Member
    Does it have a hole in it? If not, the new uploader prices it like a solid object. Just a guess ...
  5. Caponata
    Caponata New Member
    It's got 4 holes in fact. I'm guessing it's pricing it like a solid.
  6. flammableeye
    flammableeye New Member