Nintendo Controller Cut ups

Hey there, can someone help a struggling person out???

I have a basic nintendo controller that I am trying to print in specific pieces.

I have a full scaled (at least it says it is...) nintendo controller in .STL

-I need the D-pad (and underside) made into an .STL by itself (I also need an STL of the button itself)

-I need the A/B buttons (of the nintendo controller) (and the underside) By itself angled like in the picture. (I also need an STL of the button itself)

-I need the A/B buttons again (of the nintendo controller) (and the underside) By itself angled with 4 of them

So in total I just need 5 seperate files. The Dpad, the dpad button, the A/B section, the A/B section button, and the 4 button configuration. (the A/B button is the same button for the 4 button configuration).

*I have the STL of the nintendo controller attached to make everything easier

Pics of the layout:

D-pad:

A/B buttons:

C-buttons:

email: raizer012345@yahoo.com

If you would like to PM me with the details, I could have a look at making up an STL with the measurements today.
Hope your project goes well!

[edit]
Here is an example of one for you.

https://www.shapeways.com/model/708996/a2cfabe9a4b04f67b99e31 3d3763ee97